M/T Shift Lever Housing Replacement

M/T Shift Lever Housing Replacement

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the center console, dashboard, and related parts.

1. Remove the center console panel Center Console Panel Removal/Installation.

2. Remove the harness clamps.






3. Remove the cotter pin (A), the washer (B), and the shift lever housing bolts.






4. Unlock the retainer lock (A).





5. Rotate the socket holder retainer (B) counterclockwise (C) until it stops, and push the retainer lock (D) into the socket holder retainer to lock the retainer.

6. Slide the socket holder (E) and the shift cable (F) out of the shift cable bracket (G). Do not remove the shift cable by pulling the shift cable guide (H).

7. Remove the shift lever housing (A) from the shift cables (B).






8. Align the socket holder (A) on the shift cables (B) with the slot in the bracket base (C), then slide the holder into the base. Install the shift cable ends (D) to the shift lever housing (E) then install the shift lever housing.

NOTE: When installing the shift cable (shift lever side), position the serrated side (F) facing up.










9. Install the shift lever housing bolts, the washer (A), and a new cotter pin (B), then bend the cotter pin ends.

NOTE: You can install the cotter pin from either direction.






10. Install the harness clamps.





11. Install the center console panel Center Console Panel Removal/Installation.