Interior Trim Removal / Installation - Rear Tray Area

Interior Trim Removal/Installation - Rear Tray Area

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Have an assistant help you when removing and installing the bulkhead cover and the rear beam.
- Take care not to scratch the trim or the panels.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Pull up the rear tray (A) to detach the clips (B, C), then remove it.






2. Fold down the bulkhead cover.

3. Remove the bulkhead cover lids (A), then remove the bolts.






4. Pull out the alignment pins (A) of the rear beam (B) from the bulkhead cover frame both sides, then remove the bulkhead cover (C).






5. Remove these items:

- IPU module air duct IPU Module Air Duct Removal/Installation
- Rear side trims, both sides Interior Trim Removal / Installation - Cargo Area.

6. Remove the bolts, then remove the rear beam (A).






7. If necessary, remove the bolts, then remove the bulkhead cover striker (A).






8. Install the trim in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips, hooks, and pins into place securely.
- Make sure the alignment pin fits into the bulkhead cover frame correctly.
- Move the striker (A) up or down until it is centered in the bulkhead cover latch (B).