Tie Rod End: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller


Removal Procedure

1. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair) .




2. Remove and discard the rack and pinion outer tie rod end nut.





Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.

3. Disconnect the rack and pinion outer tie rod end from the steering knuckle using puller J 24319-B .

Important: Mark the location of the rack and pinion inner tie rod nut.


4. Loosen the rack and pinion inner tie rod nut and remove the rack and pinion outer tie rod end.
5. Discard the rack and pinion inner tie rod nut.
6. Clean the tapered surface of the steering knuckle.



Installation Procedure

1. Lubricate the rack and pinion inner tie rod threads with a suitable chassis lubricant.
2. Install a new rack and pinion inner tie rod nut in the same position as the old one.
3. Install the rack and pinion outer tie rod end to the rack and pinion inner tie rod.




4. Install the rack and pinion outer tie rod end to the steering knuckle.

Notice: Refer to Fastener Notice (Fastener Notice) .

5. Install the new rack and pinion outer tie rod end nut.

Tighten the nut to 71 N.m (52 lb ft).

6. Tighten the rack and pinion inner tie rod nut against the rack and pinion outer tie rod end.
7. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
8. Adjust the front toe. Refer to Front Toe Adjustment (Front Toe Adjustment) .