Power Steering Pump Replacement

Power Steering Pump Replacement

Removal Procedure

1. Remove the power steering pulley. Refer to Power Steering Pump Pulley Replacement (Power Steering Pump Pulley Replacement).
2. Place a drain pan under the pump.
3. Remove the hose guide bracket from the front of the pump.
4. Remove the hoses from the pump.
5. Remove the bolt retaining the rear bracket to the engine.




6. Remove the bolts from the front of the pump.
7. Remove the pump from the vehicle.




8. Remove the bracket (3) from the rear of the pump (1).

Installation Procedure

Caution: Refer to Fastener Caution (Fastener Caution).




1. Install the bracket (3) to the rear of the pump (1).

Tighten the rear bracket retaining nuts to 50 Nm (37 lb ft).




2. Install the pump.
3. Install the hose guide bracket bolt to the pump.
4. Install the bolt retaining the rear bracket to the engine.
5. Install the bolts to the front of the pump.

Tighten the bolts to 50 Nm (37 lb ft).

6. Install the hoses to the pump.

Tighten the nut to 28 Nm (21 lb ft).

7. Install the power steering pulley. Refer to Power Steering Pump Pulley Replacement (Power Steering Pump Pulley Replacement).
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (Service and Repair).