C1334

DTC C1332 FL SENSOR HARDWARE FAIL
DTC C1333 FR SENSOR HARDWARE FAIL
DTC C1334 RL SENSOR HARDWARE FAIL
DTC C1335 RR SENSOR HARDWARE FAIL

COMPONENT LOCATION
Refer to DTC C1121. C1121

GENERAL DESCRIPTION
Refer to DTC C1121. C1121

DTC DESCRIPTION
This DTC indicates that the FL/FR/RL/RR sensor has detected that it has an internal fault (measurement diagnosis or hardware diagnosis status). The most likely cause is sensor failure.

DTC DETECTING CONDITION





MONITOR SCANTOOL DATA
1. Connect 'TPMS exciter' or scan tool to Data Link Connector(DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "TPMS DATA VALUES" function.
4. Monitor the parameters of 'FL/FR/RL/RR WE sensor (S1/S2/S3/S4)' on the 'TPMS exciter' or scan tool.





5. Are parameter normal?

YES
> Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
> Go to "Verification of vehicle Repair" procedure.

No
> Replace FL/FR/RL/RR WE sensor and register sensor ID with 'TPMS exciter'.
> Go to "Verification of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR
Refer to DTC C1121. C1121