Removal and Installation

A/T SHIFT SELECTOR


AWD : Removal and Installation


REMOVAL
1. Remove control rod from A/T shift selector assembly.
2. Shift the selector lever to "N" position.





3. Remove knob cover (A) below selector lever downward.
4. Pull lock pin (1) out of selector lever knob (2).
5. Remove selector lever knob.
6. Remove console finisher assembly and center console assembly. Refer to Exploded View.

CAUTION:
When disconnecting selector lever position indicator connector from shift position switch, never twist or apply an excessive load to the connector.
7. Remove the rear ventilator duct 1 (with rear ventilation). Refer to
Exploded View.
8. Disconnect A/T shift selector harness connector.
9. Remove harness clips from A/T shift selector assembly.
10. Shift the selector lever to "P" position.
11. Move passenger's seat to the end.
12. Remove A/T shift selector assembly mounting bolts.





13. Slightly lift the A/T shift selector assembly (1) and slide it rightward. Then pull it out in the diagonally right direction.
14. Remove selector lever position indicator from console finisher assembly.





a. Remove ashtray (front) (1) from console finisher assembly.





b. Remove insert finisher (1) from console finisher assembly.





c. Remove the selector lever position indicator (1).
15. Remove adapter from A/T shift selector assembly.
16. Remove dust cover and dust cover plate from A/T shift selector assembly.
17. Remove dust cover plate from dust cover.
18. Remove shift lock unit from A/T shift selector assembly.
19. Remove bracket from vehicle floor panel.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
- Apply multi-purpose grease on the pin surface (that slides after installing a collar) of pivot pin.
- Apply multi-purpose grease on the surface that the shift lock unit plate slides vertically.
- When installing control rod to A/T shift selector assembly, refer to "ADJUSTMENT". Refer to Adjustments Adjustments, "AWD: Inspection and Adjustment".