Welcome Light Function

INTELLIGENT KEY SYSTEM


WELCOME LIGHT FUNCTION : System Description


CONDITION OF SEARCHING
If all the following conditions are satisfied, BCM searches for Intelligent Key by using outside key antenna
(front outside handle LH/RH and back door). BCM has timer to search for 14 days (every 0.3 sec.). If the engine is started, the timer is reset.






OPERATION PROCEDURE
BCM search outside key antenna (front outside handle LH/RH and back door) detection area. If registered
Intelligent Key is detected, BCM turn ON the room lamp and puddle lamp.
For detailed description after turning ON the lamps, refer to System Description.

SYSTEM SETTING PROCEDURE
Setting of welcome light function can be changed by the following procedure. (For system setting by CONSULT-III: refer to Intelligent Key.)
1. Check that Intelligent Key is removed from key slot.
2. Turn ignition switch ON and press and hold request switch (driver side) more than 5 seconds.
3. Confirm that buzzer sounds (combination meter).

Pi, Pi, Pi... (approx. 1.2 sec.): Welcome light function is OFF.
Pi, Pi, Pi...(approx. 2.4 sec.): Welcome light function is ON.