Special Repair Requirement (Distance Control Assist)

INSPECTION AND ADJUSTMENT


ACTION TEST : Special Repair Requirement (Distance Control Assist)


NOTE:
When the ICC system is set, the information display changes to the ICC system display.
1.ICC SYSTEM ACTION TEST
Perform the ICC system action test. Refer to ICC (Full Speed Range).
- GO TO 2.
2.CHECK DCA SWITCH
1. Start the engine.
2. After starting engine wait for 5 seconds or more.





3. Press the DCA switch (1).
4. Check that the DCA system switch indicator (2) on the information display illuminates.
5. Check that the DCA system switch indicator turns off when the system is turned OFF by pressing the DCA switch.
6. Check that the DCA system switch indicator turns OFF when the engine starts again.

NOTE:
The DCA system switch indicator does not illuminate even if the
DCA switch is turned ON within approximately 5 seconds after starting the engine.
If the accelerator pedal assembly is not replaced-INSPECTION END
If the accelerator pedal assembly is replaced-GO TO 3.
3.CHECK DCA SYSTEM OPERATION
Check that the accelerator pedal actuator operates by the "Active Test" items "ACCELERATOR PEDAL
ACTUATOR TEST1" and "ACCELERATOR PEDAL ACTUATOR TEST2" of "ACCELE PEDAL ACT" with
CONSULT-III.
- INSPECTION END