Automatic Drive Positioner Control Unit

AUTOMATIC DRIVE POSITIONER CONTROL UNIT


Removal and Installation


CAUTION:
When removing and installing, use shop cloths to protect parts from damage.

REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the instrument driver lower panel. Refer to Removal and Installation.





3. Remove the screw from the automatic drive positioner control unit (1).
4. Remove automatic drive positioner control unit (1) from bracket and disconnect electrical connectors.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Clamp the harness in position.

NOTE:
After installing the automatic drive positioner control unit, perform additional service when disconnecting battery negative terminal. Refer to Programming and Relearning.