Removal and Installation

OIL PUMP


Removal and Installation


REMOVAL
1. Remove front cover. Refer to Exploded View.





2. Remove the oil pump drive spacer.
3. Remove the oil pump.

INSTALLATION
Installation is in the reverse order of removal, paying attention of the following:





- When inserting the oil pump drive spacer, align the crankshaft key and the flat face of the inner rotor.
- If they are not aligned, rotate the oil pump inner rotor by hand.
- Make sure that the each part is aligned and tap lightly until it reaches the end.

INSPECTION AFTER INSTALLATION
- Start the engine, and check for leaks of engine oil.
- Stop engine and wait 10 minutes.
- Check level and add engine oil as required. Refer to Testing and Inspection.