Alarm Module: Service and Repair

INTELLIGENT KEY UNIT


Removal and Installation


REMOTE KEYLESS ENTRY RECEIVER

Removal
1. Remove the instrument panel. Refer to Removal and Installation.





2. Disconnect the wire harness (1), remove the bolt (A) and the
RKE receiver (2).

Installation
Installation is in the reverse order of removal.

INTELLIGENT KEY UNIT

Removal
1. Remove the instrument panel. Refer to Removal and Installation.





2. Disconnect the wire harness (1), remove the bolt (A) and the
Intelligent key unit (2).

Installation
Installation is in the reverse order of removal.

NATS ANTENNA AMP

NOTE:
- If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELF-DIAG RESULTS" on CONSULT-III screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
- Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.

Removal
1. Disconnect the battery negative terminal.
2. Remove the steering column covers. Refer to .
2. Remove the steering column covers. Refer to .





3. Remove the bolt, disconnect the electrical connector, and remove the NATS antenna amp (1).

Installation
Installation is in the reverse order of removal.