Removal and Replacement

POWER STEERING OIL PUMP


Removal and Installation


REMOVAL
1. Drain power steering fluid from reservoir tank.
2. Remove engine room cover. Refer to Service and Repair.
3. Remove air duct assembly. Refer to Removal and Installation.
4. Remove power steering reservoir tank.
5. Remove serpentine drive belt belt from auto tensioner and power steering pump. Refer to Removal and Installation.
6. Disconnect pressure sensor electrical connector.
7. Remove high pressure and low pressure piping from power steering oil pump. Refer to Service and Repair.
8. Remove bolts, then remove power steering pump.

INSTALLATION
Installation is in the reverse order of removal. Refer to Service and Repair for tightening torque.
- After installation, bleed air. Refer to Service and Repair.

NOTE:
Belt tension is automatic and requires no adjustment.