C1142

C1142 PRESS SENSOR





Description
The pressure sensor converts the brake fluid pressure to an electric signal and transmits it to the ABS actuator and electric unit (control unit). [The pressure sensor is integrated in the ABS actuator and electric unit (control unit).]




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
1. Turn the ignition switch ON.
2. Perform self-diagnosis for "ABS" with CONSULT-III.
Is DTC "C1142" detected?
YES - Proceed to diagnosis procedure. SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK STOP LAMP SWITCH
Check stop lamp switch system. C1116.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace malfunction component.
2.CHECK BRAKE SYSTEM
1. Check brake fluid leakage: Inspection.
2. Check front brake piping: Inspection After Installation.
3. Check rear brake piping: Inspection After Installation.
4. Check brake pedal: Inspection After Removal.
5. Check master cylinder: Inspection.
6. Check brake booster: Inspection Before Removal.
7. Check front disc brake: Inspection.
8. Check rear disc brake: Inspection.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace error-detected parts.
3.ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
Perform self-diagnosis for "ABS" with CONSULT-III.
Is any item indicated on the self-diagnosis display?
YES - Replace ABS actuator and electric unit (control unit).
NO - Check ABS actuator and electric unit (control unit) pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.




Special Repair Requirement
1.ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
Always perform the neutral position adjustment for the steering angle sensor, when replacing the ABS actuator and electric unit (control unit). Description.
- END