Removal And Installation

REAR BUMPER

Removal and Installation


REMOVAL


CAUTION:
Bumper fascia is made of resin. Never apply strong force to it, and be careful to prevent contact with oil.
1.Fully open back door.
2.Remove rear combination lamps (LH/RH). Removal And Installation.





3.Remove bolts (A) and clips (B) (LH/RH) located under rear combination lamps (LH/RH).





4.Remove rear fillet moldings (1) fixing screws (A) (LH/RH).
5.Remove rear fillet moldings fixing pawls and clips (LH/RH).
Removal And Installation.










6.Remove bumper fascia assembly fixing screws (A) (LH/RH).





7.Remove bumper fascia assembly underside fixing clips (A).





8.Disconnect bumper sub harness connector (A).





9.Pull both sides bumper fascia assembly toward the vehicle out side to disengage the bumper fascia assembly from bumper side brackets (LH/RH).





10.Remove bumper fascia assembly.

CAUTION:
When removing bumper fascia, 2 workers are required so as to prevent it from dropping.
11.Remove the following parts after removing bumper fascia.
- Reflex reflectors (LH/RH).
- Sonar sensors (LH/RH). Removal And Installation.
- Bumper sub harness.
12.Remove bumper energy absorber.
13.Remove bumper reinforcement mounting nuts and bolts, and then remove bumper reinforcement with power tool.

INSTALLATION

Install in the reverse order of removal.
NOTE:





After installing, perform fitting adjustment.