CONSULT-II Reference Value in Data Monitor Mode

Consult Reference Values (Part 1 Of 2):

Consult Reference Values (Part 2 Of 2):

CONSULT REFERENCE VALUES IN DATA MONITOR MODE
Remarks:
- Specification data are reference values.
- Specification data are output/input values which are detected or supplied by the Engine Control Module (ECM) at the connector.

* Specification data may not be directly related to their components signals/values/operations.
(i.e., Adjust ignition timing with a timing light before monitoring IGN TIMING. Specification data might be displayed even when ignition timing is not adjusted to specification. This IGN TIMING monitors the data calculated by the ECM according to the input signals from the camshaft position sensor and other ignition timing related sensors.)

- If the real-time diagnosis results are NG, and the on-board diagnostic system results are OK, when diagnosing the mass air flow sensor, first check to see if the fuel pump control circuit is normal.