Procedure 2 Inspecting Malfunctioning Parts - CONSULT Scan Tool
Inspecting SRS malfunctioning parts by using CONSULT-II - Diagnosis mode1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" to Data link connector.
3. Turn ignition switch "ON".
4. Touch "START".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [CURRENT]".
7. Diagnostic codes are displayed on "SELF-DIAG [CURRENT]".
If no malfunction is detected on "SELF-DIAG [CURRENT]" but malfunction is indicated by the "AIR BAG" warning lamp, go to DIAGNOSTIC PROCEDURE 6, to diagnose the following situations:
Procedure 6 Inspecting SRS Malfunctioning Record
- Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.
8. Touch "PRINT".
9. Compare diagnostic codes to the CONSULT-II DIAGNOSTIC CODE CHART.
10. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears in order to return to User mode from Diagnosis mode.
11. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II and disconnect both battery cables.
12. Repair the system as outlined by the "Repair order" in CONSULT-II DIAGNOSTIC CODE CHART, that corresponds to the self-diagnosis result.
13. After repairing the system, go to DIAGNOSTIC PROCEDURE 4 for final checking.
Procedure 4 Final Check After Repairing SRS
CONSULT-II can only show one seat belt pre-tensioner malfunction as self-diagnosis result at a time. Check self-diagnosis result with CONSULT-II whether other malfunctions are detected after repairing one seat belt pre-tensioner malfunction.