Procedure 8 Inspecting SRS Intermittent Problem
Inspecting SRS intermiffent malfunction by using CONSULT-II - Diagnosis mode1. Turn ignition switch "OFF".
2. Connect "CONSULT-II" to Data link connector.
3. Turn ignition switch "ON".
4. Touch "START".
5. Touch "AIR BAG".
6. Touch "SELF-DIAG [PAST]".
7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.
If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
NOTE: Past malfunction for seat belt pre-tensioner system will not be displayed on "SELF-DIAG [PAST]".
8. Touch "TROUBLE DIAG RECORD".
NOTE: With TROUBLE DIAG RECORD, diagnosis results previously erased by a reset operation can be displayed.
9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to the INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART.
12. Touch "BACK" key of CONSULT-II until SELECT SYSTEM appears.
13. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II and disconnect both battery cables.
14. Repair the system as outlined by the "Repair order" in INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART that corresponds to the self-diagnosis result.
15. Go to DIAGNOSTIC PROCEDURE 4, for final checking. Procedure 4 Final Check After Repairing SRS