P1762

DTC P1762 DIRECT CLUTCH SOLENOID VALVE
Description
Direct clutch solenoid valve is controlled by the TCM in response to signals sent from the PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be shifted to the optimum position.





CONSULT-II Reference Value

On Board Diagnosis Logic
^ This is an OBD-II self-diagnostic item.
^ Diagnostic trouble code P1762 D/C SOLENOID/CIRC with CONSULT-II or 2nd judgement flicker without CONSULT-II is detected under the following conditions.
^ When TCM detects an improper voltage drop when it tries to operate the solenoid valve.
^ When TCM detects as irregular by comparing target value with monitor value.

Possible Cause
^ Harness or connectors. (Solenoid circuit is open or shorted.)
^ Direct clutch solenoid valve.

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If DTC Confirmation Procedure has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II





1. Turn ignition switch ON. (Do not start engine.)
2. Select MAIN SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.
3. Touch START.
4. Start engine.
5. Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
THROTTLE POSI: 1.5/8 - 2.0/8
SLCTLVR POSI: D position
GEAR: 1 -> 2 (D/C ON/OFF)
Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
6. If DTC is detected, go to Diagnostic Procedure.

WITH GST
Follow the procedure With CONSULT-II.

Diagnostic Procedure
1. CHECK INPUT SIGNAL

With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select MAIN SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.
3. Start the engine.








4. Read out the value of D/C SOLENOID while driving.
OK or NG
OK >> GO TO 4.
NG >> GO TO 2.

2. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to MAIN POWER SUPPLY AND GROUND CIRCUIT.
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.

3. DETECT MALFUNCTIONING ITEM
Check the following.
^ A/T assembly harness connector pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> Replace control valve with TCM. Refer to Control Valve with TCM and A/T Fluid Temperature Sensor 2.
NG >> Repair or replace damaged parts.

4. CHECK DTC
Perform DTC Confirmation Procedure.
OK or NG
OK >> INSPECTION END
NG >> GO TO 2.