Check Sliding Motor Circuit

AUTOMATIC DRIVE POSITIONER


Check Sliding Motor Circuit

1.CHECK SEAT SLIDING MECHANISM
Check the following.
- Operation malfunction caused by sliding rail deformation, pinched harness or other foreign materials
- Operation malfunction caused by foreign materials adhered to the sliding motor or sliding rail connector rod
- Operation malfunction and interference with other parts by poor installation
OK or NG
OK - GO TO 2.
NG - Repair or replace the malfunctioning part and check again.
2.CHECK FUNCTION
With CONSULT-III
Check operation with "SEAT SLIDE" in ACTIVE TEST.





OK or NG
OK - Sliding motor circuit is OK.
NG - GO TO 3.
3.CHECK SLIDING MOTOR CIRCUIT HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect driver seat control unit and sliding motor connector.
3. Check continuity between driver seat control unit connector and sliding motor connector.










4. Check continuity between driver seat control unit connector and ground.





OK or NG
OK - GO TO 4.
NG - Repair or replace harness.
4.CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL
1. Connect the driver seat control unit connector.





2. Check voltage between driver seat control unit connector and ground.





OK or NG
OK - Replace sliding motor.
NG - Replace driver seat control unit.