Wheel Sensor

WHEEL SENSOR


Removal and Installation


COMPONENT











NOTE:
The above figure (front side) shows left side. Right side is the mirror image.

REMOVAL
Pay attention to the following when removing sensor.

CAUTION:
- Do not twist sensor harness as much as possible, when removing it. Pull sensors out without pulling on sensor harness.
- Take care to avoid damaging sensor edges or rotor teeth. Remove wheel sensor first before removing front or rear wheel hub. This is to avoid damage to sensor wiring and loss of sensor function.

INSTALLATION
Pay attention to the following when installing wheel sensor. Tighten installation bolts to the specified torques.
- When installing, make sure there is no foreign material such as iron chips on and in the mounting hole of the wheel sensor. Make sure no foreign material has been caught in the sensor rotor. Remove any foreign material and clean the mount.
- When installing wheel sensor, be sure to press rubber grommets in until they lock at locations shown above in the figure. When installed, harness must not be twisted.