Front Bumper Cover
Front Bumper Cover (76.22.78)
Removal
All vehicles
1. Remove the radiator splash shield retaining bolts.
2. NOTE: Left-hand shown, right-hand similar.
Detach the wheel arch liner.
3. Disconnect the bumper wiring harness electrical connector.
4. NOTE: Left-hand shown, right-hand similar.
Detach the bumper cover.
Vehicles with headlamp washer
5. NOTE: Left-hand shown, right-hand similar.
Apply suitable tape to the bumper cover to prevent damage to the bumper cover.
6. NOTE: Left-hand shown, right-hand similar.
Reposition the headlamp washers to the fully open position.
7. NOTE: Left-hand shown, right-hand similar.
Remove the headlamp washer cover.
All vehicles
8. NOTE: Left-hand shown, right-hand similar.
Detach the side of the bumper cover from the retaining clips.
9. CAUTION: Make sure the bumper cover is supported before removing the securing bolts.
NOTE: Left-hand shown, right-hand similar.
Remove the bumper cover.
- Remove the bumper cover securing bolts.
Installation
1. To install, reverse the removal procedure.
Tighten to 7 Nm.
2. Tighten to 7 Nm.