Fender Splash Shield

Fender Splash Shield

Removal
1 Disconnect the battery ground cable.
2
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3 Remove the LH front wheel and tire. For additional information, refer to Wheel and Tire Service and Repair




4 Remove the fender splash shield, rear section.
- Remove the 6 Torx bolts.
- Remove the clip.
- Remove the 2 nuts.




5 Remove the fender splash shield, front section.
- Remove the 13 Torx bolts.

Installation
1 Install the fender splash shield, front section.
- Tighten the Torx bolts.
2 Install the fender splash shield, rear section.
- Tighten the Torx bolts.
- Tighten the nuts.
- Install the clip.
3 Install the wheel and tire. For additional information, refer to Wheel and Tire Service and Repair
4 Connect the battery ground cable.