Rear Brake Disc
Brake Disc
Removal
WARNING: Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2 Remove the rear brake pads. For additional information, refer to Brake Pads - Vehicles With: Standard Brakes Rear Disc Brake Pads
3 Tie the brake caliper aside.
4 Remove the brake caliper anchor plate.
- Remove and discard the 2 bolts.
5 Remove the brake disc.
- Remove the 2 clips.
Installation
1
WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
Install the brake disc.
- Clean the component mating faces.
- Secure the clips.
2 Install the brake caliper anchor plate.
- Clean the component mating faces.
- Tighten the bolts to 103 Nm (76 lb.ft).
3 Install the brake pads. For additional information, refer to Brake Pads - Vehicles With: Standard Brakes Rear Disc Brake Pads