Side Repeater Lamp - Removal

LAMP

NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.





1. Disconnect and isolate the battery negative cable.

NOTE: The same repeater lamp is used on both sides of the vehicle. Regardless of which side of the vehicle the lamp is on, when properly oriented the fixed hook tab integral to the back of the lamp housing engages the edge of the fender mounting hole that is not notched and the latch feature engages the edge of the fender mounting hole that is notched.

2. Using hand pressure, press one edge of the repeater lamp lens/housing (1) against the spring pressure of the latch feature, then pull the edge of the lamp outward far enough to disengage the fixed hook tab from the side of the fender mounting hole (3).
3. Pull the lamp out from the fender far enough to access and disconnect the wire harness connector (2) from the bulb socket on the back of the lamp lens/housing.
4. Remove the repeater lamp from the fender.