Front Door Window Motor: Service and Repair

Front Door Window Regulator Motor

Removal
1 Remove the front door window glass. For additional information, refer to Front Door Window Glass Service and Repair




2 Release the front door window regulator and motor from the side impact protection beam.
- Disconnect the electrical connector.
- Remove the bolt.
- Remove the clip.
- Remove the clamp.




3 Remove the front door window regulator and motor.
- Remove and discard the 2 lower bolts.
- Remove the 3 upper bolts.

Installation
1 Install the front door window regulator and motor.
- Remove the 2 clips.
- Install the clamp.
- Tighten the 4 upper bolts to 10 Nm (7 lb.ft).
- Tighten the 2 new lower bolts to 10 Nm (7 lb.ft).
- Install the clip.
2 Connect the front door window regulator and motor electrical connector.
3 Install the front door window glass. For additional information, refer to Front Door Window Glass Service and Repair