Installation

2GR-FE ENGINE CONTROL SYSTEM: CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Exhaust Side)






(a) Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve.






(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the camshaft timing oil control valve connector.
2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Intake Side)






(a) Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve.






(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
Connect the camshaft timing oil control valve connector.
3. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Exhaust Side)






(a) Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve.






(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the camshaft timing oil control valve connector.
4. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1 Intake Side)






(a) Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve.






(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the camshaft timing oil control valve connector.
5. INSTALL INTAKE AIR SURGE TANK ASSEMBLY Installation

6. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

7. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

8. INSTALL NO. 1 AIR CLEANER INLET Installation

9. INSTALL NO. 2 AIR CLEANER INLET Installation

10. ADD ENGINE COOLANT Testing and Inspection

11. INSPECT FOR COOLANT LEAK Testing and Inspection

12. INSPECT FOR OIL LEAK Replacement

13. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

14. INSTALL COWL TOP OUTER PANEL SUB-ASSEMBLY






(a) Remove the 6 set nuts of the shock absorber.
(b) Install the cowl top panel outer with the 4 bolts and 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
(c) Install the shock absorber with the 4 set nuts.
Torque: 80 Nm (815 kgf-cm, 59 ft-lbf)
(d) Install the 2 front shock absorber caps with the 6 nuts. (with Air Suspension)
Torque: 80 Nm (815 kgf-cm, 59 ft-lbf)
(e) Install the grommet.
(f) Install the 2 wire harness clamps.
(g) Connect the rain sensor connector. (with Auto Wiper)
15. INSTALL WINDSHIELD WIPER LINK ASSEMBLY