Outer Rear View Mirror

MIRROR: OUTER REAR VIEW MIRROR: INSPECTION

INSPECTION

1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (w/o Seat Position Memory System)





(a) Inspect outer mirror operation.
(1) Disconnect the mirror connector.
(2) Apply battery voltage and check operation of the mirror face.
Standard:










(b) Inspect outer mirror heater operation.
(1) Apply battery voltage and check operation of the mirror heater.
HINT: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
If the result is not as specified, replace the mirror assembly

OK:






2. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH (w/ Seat Position Memory System)





(a) Inspect outer mirror operation.
(1) Disconnect the mirror connector.
(2) Apply battery voltage and check operation of the mirror face.
Standard:










(b) Inspect outer mirror heater operation.
(1) Apply battery voltage and check operation of the mirror heater.
HINT: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
If the result is not as specified, replace the mirror assembly

OK:






(c) Inspect operation of the mirror position sensor.
(1) Connect the positive (+) lead from the ohmmeter to terminal 9 and the negative (-) lead to terminal 15, and measure the resistance.
Standard resistance:
700 to 1,300Ohms
(2) Check that the resistance between terminals 9 and 10 changes when slowly turning the mirror face right and left.
(3) Check that the resistance between terminals 9 and 16 changes when slowly turning the mirror face right and left.
3. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH (w/o Seat Position Memory System)
(a) Inspect outer mirror operation.




(1) Disconnect the H8 mirror connector.
(2) Apply battery voltage and check operation of the mirror face.
Standard:










(b) Inspect outer mirror heater operation.
(1) Apply battery voltage and check operation of the mirror heater.
HINT: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

OK:






If the result is not as specified, replace the mirror assembly.
4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY RH (w/ Seat Position Memory System)
(a) Inspect outer mirror operation.




(1) Disconnect the H8 mirror connector.
(2) Apply battery voltage and check operation of the mirror face.
Standard:










(b) Inspect outer mirror heater operation.
(1) Apply battery voltage and check operation of the mirror heater.
HINT: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

OK:






If the result is not as specified, replace the mirror assembly.
(c) Inspect operation of the mirror position sensor.
(1) Connect the positive (+) lead from the ohmmeter to terminal 9 and the negative (-) lead to terminal 15, and measure the resistance.
Standard resistance:
700 to 1,300Ohms
(2) Check that the resistance between terminals 9 and 10 changes when slowly turning the mirror face right and left.
(3) Check that the resistance between terminals 9 and 16 changes when slowly turning the mirror face right and left.