Removal

SUSPENSION: REAR PNEUMATIC CYLINDER: REMOVAL

REMOVAL

1. REMOVE PNEUMATIC CYLINDER ASSEMBLY REAR LH
(a) Jack up vehicle and support the frame with safety stands.
NOTICE:
- Do the work with the rear axle assembly lowered.
- Do the work with the shock absorber installed.

(b) Disconnect the height control tube Suspension Control System.





(c) Remove the clip on the upper side of the pneumatic cylinder Suspension Control System.
HINT: If the clip cannot easily be removed, thread a wire through the hole to pull it.

(d) Discharge air from the pneumatic cylinder assembly to retract it.





(e) Turn the pneumatic cylinder assembly 90 degrees and remove it from the rear axle assembly.
NOTE:
Do not extend the pneumatic cylinder assembly.
HINT: If the pneumatic cylinder assembly is to be reused, 2 new O-rings as well as a new plate and height control plug must be used Suspension Control System.