Installation

SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY





(a) Check the degree of tilt when the ELR begins to lock.
(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt when gently moving the installed retractor.
NOTICE:
Do not disassemble the retractor.





(b) Temporarily install the front seat outer belt assembly with the 2 bolts.
(c) Fully tighten the upper side bolt first, then the lower side bolt to install the front seat outer belt assembly.
For upper bolt - Torque: 7.5 Nm (77 kgf-cm, 66in-lbf)
For lower bolt - Torque: 42 Nm (428 kgf-cm, 31ft-lbf)





(d) Connect the tension reducer connector.
(e) Connect the pretensioner connector and lock the locking button.
NOTICE:
Securely lock the locking button.

(f) Connect the shoulder side of the front seat outer belt assembly with the nut.
Torque: 42 Nm (428 kgf-cm, 31ft-lbf)
2. INSTALL CENTER PILLAR GARNISH
3. INSTALL CENTER PILLAR GARNISH LOWER
4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY
(a) Connect the floor side of the front seat outer belt assembly with the bolt.
Torque: 42 Nm (428 kgf-cm, 31ft-lbf)
(b) Check if the ELR locks.
NOTICE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
5. INSTALL LAP BELT OUTER ANCHOR COVER
6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
7. INSTALL REAR DOOR SCUFF PLATE
8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
9. INSTALL FRONT DOOR SCUFF PLATE
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
Some systems need initialization when disconnecting the cable from the negative battery cable.
12. INSPECT SRS WARNING LIGHT
HINT:
Diagnosis System