Installation

SUSPENSION: FRONT STABILIZER BAR (for 2WD): INSTALLATION

INSTALLATION

1. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar to the vehicle.
2. INSTALL FRONT NO.1 STABILIZER BAR BUSHING





(a) Install front No. 1 stabilizer bar bushing.
HINT: Install the bush to the outer side of the bush stopper on the stabilizer bar.

3. INSTALL POWER STEERING LINK ASSEMBLY
4. INSTALL PRESSURE FEED TUBE ASSEMBLY
5. INSTALL STEERING GEAR OUTLET RETURN TUBE
6. CONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
7. INSTALL TIE ROD END SUB-ASSEMBLY LH
8. INSTALL TIE ROD END SUB-ASSEMBLY RH
HINT: Install the RH side side following the same procedures as with the LH side.

9. INSTALL FRONT NO.2 STABILIZER BRACKET LH
(a) Install the front stabilizer bracket No. 2 from the stabilizer bar bush No. 1.
10. INSTALL FRONT NO.2 STABILIZER BRACKET RH
HINT: Install the RH side side following the same procedures as with the LH side.

11. INSTALL FRONT STABILIZER BRACKET NO.1 LH





(a) Install the 2 front No. 1 stabilizer brackets LH with the 2 bolts.
for TMC Made - Torque: 29 Nm (296 kgf-cm, 21ft-lbf)
for TMMK Made - Torque: 16 Nm (163 kgf-cm, 12ft-lbf)
12. INSTALL FRONT STABILIZER BRACKET NO.1 RH
HINT: Install the RH side side following the same procedures as with the LH side.

13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH





(a) Install the front stabilizer link assembly LH with the 2 nuts.
Torque: 74 Nm (755 kgf-cm, 55ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.

14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Install the RH side side following the same procedures as with the LH side.

15. INSTALL FRONT WHEELS
Torque: 103 Nm (1050 kgf-cm, 76ft-lbf)
16. BLEED POWER STEERING FLUID
17. CHECK POWER STEERING FLUID LEAKAGE
18. INSPECT POWER STEERING FLUID LEVEL
19. INSPECT AND ADJUST STEERING WHEEL CENTER POINT
20. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT