Carpet: Service and Repair
REMOVAL1. REMOVE FRONT SEATS
Torque: 37 N.m (375 kgf.cm, 27 ft.lbf)
2. REMOVE REAR SEAT CUSHION
3. REMOVE REAR SEAT BELT LOWER SIDE BOLTS
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
4. REMOVE REAR SEATBACK
Torque: 18 N.m (185 kgf.cm, 13 ft.lbf)
5. REMOVE FRONT DOOR SCUFF INSIDE PLATES
6. REMOVE COWL SIDE TRIMS
7. REMOVE FRONT SEAT OUTER BELT FLOOR ANCHOR BOLTS
Torque: 42 N.m (430 (kgf.cm, 31 ft.lbf)
8. REMOVE ROOF SIDE INNER GARNISH
a. Remove the clip.
b. Using a screwdriver, pry loose and remove the garnish.
HINT: Tape the screwdriver tip before use.
c. Employ the same manner described above to the other side.
9. REMOVE REAR SEAT SIDE GARNISH
a. Remove the clip.
b. Pry loose and remove the garnish.
c. Employ the same manner described above to the other side.
10. REMOVE LOWER CENTER PILLAR GARNISH
a. Using a screwdriver, pry off the garnish.
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
11. REMOVE UPPER CONSOLE PANEL
Using a screwdriver, remove the upper console panel.
HINT: Tape the screwdriver tip before use.
12. REMOVE REAR CONSOLE BOX
a. Remove the box bottom No.2 mat.
b. Remove the 2 bolts, 2 screws and rear console box.
13. REMOVE FOOTREST
a. Using a screwdriver, remove the 2 covers.
HINT: Tape the screwdriver tip before use.
b. Unfasten 2 screws and remove the footrest.
14. REMOVE FLOOR CARPET
Slide the carpet backward and remove it.
INSTALLATION
Installation is in the reverse order of removal.