Installation

2GR-FSE ENGINE MECHANICAL: DRIVE BELT:

INSTALLATION

1. INSTALL V-RIBBED BELT






(a) Install the V-ribbed belt.
(b) While turning the belt tensioner counterclockwise, remove the bar.
NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.





(c) If it is difficult to install the V-ribbed belt, perform the following procedure.
(1) Put the V-ribbed belt on every part except the tensioner pulley as shown in the illustration.
(2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.
NOTICE:
- Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
- Check that the V-ribbed belt is properly set to each pulley.

2. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

3. INSTALL NO. 1 INLET AIR CLEANER Installation

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation