Removal

EXTERIOR: FRONT BUMPER:

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL





(a) Remove the 7 clips and cool air intake duct seal.
2. REMOVE FRONT BUMPER ASSEMBLY





(a) Put protective tape around the front bumper assembly.





(b) Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
HINT: Use the same procedures for the RH side and LH side.





(c) Remove the 9 screws, 2 clips, 2 radiator grille protectors and bolt.





(d) Disengage the 3 claws and disconnect the front bumper assembly as shown in the illustration.
HINT: Use the same procedures for the RH side and LH side.

(e) Disconnect each connector, and then remove the front bumper assembly.