Removal

2GR-FSE COOLING: WATER PUMP: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ENGINE UNDER COVER Removal

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER LH Removal

5. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

6. REMOVE NO. 1 AIR CLEANER INLET Removal

7. DRAIN ENGINE COOLANT (for Engine) Service and Repair

8. DISCONNECT RADIATOR HOSE INLET

9. DISCONNECT RADIATOR HOSE OUTLET

10. REMOVE FAN AND GENERATOR V-RIBBED BELT Removal

11. REMOVE NO. 2 ENGINE COVER





(a) Remove the 3 nuts and engine harness cover (LH bank side).





(b) Remove the 3 nuts and cover.

12. REMOVE NO. 1 ENGINE COVER Removal

13. REMOVE INJECTOR DRIVER Removal

14. REMOVE WATER INLET





(a) Disconnect the 5 hoses.





(b) Remove the 4 bolts, nut and water inlet.





(c) Remove the water inlet housing gasket and water outlet pipe's O-ring.

15. REMOVE ELECTRIC INVERTER COMPRESSOR Removal

16. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal

17. REMOVE WATER PUMP PULLEY





(a) Using SST, hold the water pump pulley.

SST : 09960-10010

09962-01000

09963-00700

(b) Remove the 4 bolts and water pump pulley.

18. REMOVE WATER PUMP ASSEMBLY





(a) Remove the 16 bolts, water pump and gasket.