On-Vehicle Inspection

SLIDING ROOF: SLIDING ROOF SYSTEM: ON-VEHICLE INSPECTION

1. CHECK AUTO OPERATION

NOTICE:
Make sure that initialization is completed before inspection Initialization.

HINT
When pressing the switch for 0.3 seconds or less, the roof glass moves but auto operation does not operate.

(a) Turn the engine switch on (IG).

(b) When the roof glass is fully closed, press the SLIDE OPEN switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully opened.

(c) When the roof glass is fully open, press the SLIDE CLOSE switch for 0.3 seconds or more. Check that the roof glass automatically slides until it is fully closed.

(d) When the roof glass is fully closed, press the TILT UP switch for 0.3 seconds or more. Check that the roof glass automatically tilts up until it is fully tilted upward.

(e) When the roof glass is fully open, press the TILT DOWN switch for 0.3 seconds or more. Check that the roof glass automatically tilts down until it is fully tilted downward.

(f) When the auto operation is operating, check that pressing any sliding roof switch stops the roof glass operation.

2. CHECK SLIDING ROOF OPERATION AFTER ENGINE SWITCH IS TURNED OFF

(a) Turn the engine switch from on (IG) to off, and check that the sliding roof operates. Then open and close the driver side door once, and check that the sliding roof does not operate.

(b) Turn the engine switch from on (IG) to off and wait for approximately 43 seconds. Check that the sliding roof does not operate.

(c) Operate the auto operation. While the roof glass is in motion, turn the engine switch off. Check that the auto operation continues until the roof glass opens or closes fully.

3. CHECK JAM PROTECTION FUNCTION

CAUTION:
* Do not use a part of your body, for example, your hand, to check the jam protection function.
* Do not allow anything to become caught in the sliding roof by accident in this procedure.
* Perform the inspection from the inside of the vehicle.
NOTICE:
* Do not use hard objects such as a hammer, to avoid damage to the roof.
* If the jam protection function does not operate, reset the sliding roof drive gear (motor).





(a) When the auto slide close function is operating, and an object is caught between the vehicle body and glass, check that the roof glass opens a distance of 218 mm (8.58 in.) from the point of contact with the object, or opens fully if an opening distance of 218 mm (8.58 in.) is not available.





(b) When the auto tilt down function is operating, and an object is caught between the vehicle body and the roof glass, check that the sliding roof tilts up fully.

4. CHECK TRANSMITTER-LINKED OPERATION*

HINT
* *: except for models with Navigation System (for DVD)
* The sliding roof's transmitter-linked operation can be customized to perform either the sliding operation or tilting operation.
HINT
The sliding roof's transmitter-linked operation can be customized to perform either the sliding operation or tilting operation.

(a) Close all the doors.

(b) Hold down the transmitter's UNLOCK switch for approximately 3.4 seconds or more and check that the slide open/tilt up operation occurs. Also, when the UNLOCK switch is released, check that the roof glass stops moving.

5. CHECK KEY-LINKED OPERATION (DRIVER'S DOOR ONLY)

HINT
The sliding roof's key-linked operation can be customized to perform either the sliding roof sliding operation or tilting operation.

(a) Insert the key into the driver side door's key lock cylinder, and turn the key to the UNLOCK position for approximately 2.5 seconds or more. Check that the sliding roof starts moving (slide open/tilt up operation). Then release the key and check that the sliding roof stops moving.

(b) Insert the key into the driver side door's key lock cylinder, and turn the key to the LOCK position for approximately 2.5 seconds or more. Check that the sliding roof starts moving (slide close/tilt down operation). Then release the key and check that the sliding roof stops moving.