TRAC OFF Indicator Light Remains ON
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: TRAC OFF Indicator Light Remains ON
- TRAC OFF Indicator Light Remains ON
DESCRIPTION
The skid control ECU is connected to the combination meter via the CAN and multiplex communication systems.
Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If TR(A)C control turns off, the TR(A)C OFF message will be displayed on the multi-information display.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration and store system information Programming and Relearning.
PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
(a) Check if a CAN communication system DTC is output Diagnosis System.
Result:
B -- INSPECT CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.
2. CHECK MULTIPLEX COMMUNICATION SYSTEM
(a) Check if a multiplex communication system DTC is output Reading and Clearing Diagnostic Trouble Codes.
Result:
B -- INSPECT MULTIPLEX COMMUNICATION SYSTEM Diagnostic Trouble Code Descriptions
A -- Continue to next step.
3. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
(a) Check if the skid control ECU connector is securely connected.
OK:
The connector is securely connected.
NG -- CONNECT CONNECTOR TO ECU CORRECTLY
OK -- Continue to next step.
4. CHECK BATTERY
(a) Check the battery voltage.
Standard Voltage:
11 to 14 V
Result:
C -- CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 4GR-FSE) Component Tests and General Diagnostics
B -- CHECK OR REPLACE CHARGING SYSTEM OR BATTERY (for 2GR-FSE) Component Tests and General Diagnostics
A -- Continue to next step.
5. READ VALUE USING TECHSTREAM (VSC OFF SWITCH)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Select the Data List on the Techstream Data List / Active Test.
ABS/VSC/TRAC
ABS/VSC/TRAC:
(d) Using the Techstream, check the switch condition on the Techstream changes according to VSC OFF switch operation.
OK:
The Techstream display changes according to VSC OFF switch operation.
NG -- INSPECT VSC OFF SWITCH
OK -- Continue to next step.
6. INSPECT COMBINATION METER ASSEMBLY
(a) Turn the engine switch off.
(b) Perform the Active Test of the combination meter (meter CPU) using the Techstream Scan Tool Testing and Procedures.
(c) Check the combination meter.
OK:
The multi-information display (TR(A)C OFF indicator) turns on or off in accordance with the Techstream operation.
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.
NG -- REPLACE COMBINATION METER ASSEMBLY Removal
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal
7. INSPECT VSC OFF SWITCH
(a) Turn the engine switch off.
(b) Disconnect the VSC OFF switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE VSC OFF SWITCH
OK -- Continue to next step.
8. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)
(a) Disconnect the skid control ECU connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal