Register Illumination

LIGHTING: REGISTER ILLUMINATION: INSPECTION

1. INSPECT REGISTER ILLUMINATION (LH Side)

(a) Disconnect the connector from the register.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(c) If the result is not as specified, repair or replace the wire harness or connector.

(d) Connect the (+) lead from the battery to terminal 1 and the (-) lead to terminal 2.





(e) Check that the register illumination comes on.

OK:

Comes on

(f) If the result is not as specified, replace the register illumination.

2. INSPECT REGISTER ILLUMINATION (RH Side)

(a) Disconnect the connector from the register.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(c) If the result is not as specified, repair or replace the wire harness or connector.

(d) Connect the (+) lead from the battery to terminal 1 and the (-) lead to terminal 2.





(e) Check that the register illumination comes on.

OK:

Comes on

(f) If the result is not as specified, replace the register illumination.

3. INSPECT REGISTER ILLUMINATION (Center)

(a) Disconnect the connector from the register.





(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





(c) If the result is not as specified, repair or replace the wire harness or connector.

(d) Connect the (+) lead from the battery to terminal 1 and the (-) lead to terminal 2.





(e) Check that the register illumination comes on.

OK:

Comes on

(e) If the result is not as specified, replace the register illumination.