Installation

MIRROR: INNER REAR VIEW MIRROR: INSTALLATION

1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System)





NOTICE:
* Do not touch the camera lens (built into the inner rear view mirror assembly) with a bare hand.
* Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).
* Do not apply strong impacts to the inner rear view mirror assembly.
* Do not allow any liquid to get on the inner rear view mirror assembly.
(a) Using a T20 "TORX" socket wrench, install the inner rear view mirror with the screw.

Torque : 1.8 Nm (18 kgf-cm, 16 in-lbf)

(b) Connect the connector.

2. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System)





(a) Using a T20 "TORX" socket wrench, install the inner rear view mirror with the screw.

Torque : 1.8 Nm (18 kgf-cm, 16 in-lbf)

(b) Connect the connector.

3. INSTALL RAIN SENSOR COVER (w/o Lane Keeping Assist System)





(a) Attach the 2 claws to install the rain sensor cover.

(b) Push the stopper as shown in the illustration to fix the cover in place.

4. INSTALL RAIN SENSOR COVER (w/ Lane Keeping Assist System)





NOTICE:
When removing and installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".





(a) While being careful not to apply force to the camera area, attach the 2 claws and 2 clips to install the rain sensor cover.

(b) Push the stopper as shown in the illustration to fix the cover in place.

5. INSTALL MAP LIGHT ASSEMBLY Installation