Installation

2GR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY: INSTALLATION

1. INSTALL THROTTLE BODY

(a) Install a new throttle body gasket to the intake air surge tank.

(b) Install the throttle body with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the 2 water by-pass hoses.

(d) Connect the throttle body connector and clamp.

2. INSTALL NO. 1 AIR CLEANER INLET Installation

3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

(a) Install the air cleaner cap sub-assembly, and connect the 3 bands.

(b) Connect the mass air flow meter connector (*1).

5. INSTALL AIR CLEANER INLET ASSEMBLY Installation

6. ADD ENGINE COOLANT Testing and Inspection

7. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection

8. CHECK FUNCTION OF THROTTLE BODY On-Vehicle Inspection

9. INSTALL ENGINE ROOM SIDE COVER LH Installation

10. INSTALL COOL AIR INTAKE DUCT SEAL Installation

11. INSTALL V-BANK COVER SUB-ASSEMBLY Installation