Removal

2GR-FE STARTING: STARTER: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. REMOVE NO. 2 AIR CLEANER INLET Removal

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

8. REMOVE NO. 1 AIR CLEANER INLET Removal

9. REMOVE STARTER ASSEMBLY

(a) Disconnect the terminal 50 connector from the starter assembly.





(b) Remove the nut and disconnect the wire harness from terminal 30.

(c) Remove the 2 bolts and starter assembly.