Operation CHARM: Car repair manuals for everyone.
Home >> Lexus >> 2011 >> LS 460 AWD V8-4.6L (1UR-FSE) >> Repair and Diagnosis >> Body and Frame >> Locks >> Keyless Entry >> Testing and Inspection >> Pinout Values and Diagnostic Parameters >> Wireless Door Lock Control System
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wireless Door Lock Control System





DOOR LOCK: WIRELESS DOOR LOCK CONTROL SYSTEM: TERMINALS OF ECU

1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)





(a) Disconnect the DA, DD, DF, L12 and L13 ECU connectors.

(b) Measure the resistance and voltage according to value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the DA, DD, DF, L12 and L13 ECU connectors.

(d) Measure the voltage according to the value(s) in the table below.





* If the result is not as specified, the ECU may have a malfunction.

2. CHECK FRONT MULTIPLEX NETWORK LIGHT ECU (FRONT CONTROLLER)





(a) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the ECU may have a malfunction.

3. CHECK LUGGAGE ROOM JUNCTION BLOCK (REAR JUNCTION BLOCK ECU) (w/o Power Trunk Lid System)





(a) Measure the resistance according to the value(s) in the table below.





If the result is not as specified, the ECU may have a malfunction.

4. CHECK POWER TRUNK LID CONTROL ECU (w/ Power Trunk Lid System)





(a) Disconnect the S43 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the S43 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the ECU may have a malfunction.

(e) Using an oscilloscope, check the waveform.





Waveform (Reference)





5. CHECK CERTIFICATION ECU





(a) Disconnect the L15 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.





If the result is not as specified, there may be a malfunction on the wire harness side.

(c) Reconnect the L15 ECU connector.

(d) Measure the voltage according to the value(s) in the table below.





If the result is not as specified, the ECU may have a malfunction.
pro multis · About Operation CHARM