Removal

STEERING COLUMN: TILT AND TELESCOPIC MANUAL SWITCH: REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Disable the AUTO TILT AWAY function by changing the customize parameter Programming and Relearning.

NOTICE:
Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

HINT
Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.

(b) Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

(c) Turn the engine switch off and disconnect the cable from the negative battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera)

(a) Remove the 2 screws.





HINT
Turn the steering wheel to the right and left as necessary to remove the 2 screws.

(b) Remove the screw.





(c) Detach the 2 claws to remove the steering column lower cover.

(d) Detach the 5 clips to separate the steering column upper cover.





4. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera)

(a) Remove the 2 screws.





HINT
Turn the steering wheel to the right and left as necessary to remove the 2 screws.

(b) Remove the screw.





(c) Detach the 2 claws to remove the steering column lower cover.

(d) Disconnect the connector.

(e) Detach the claw and 4 clips and remove the cover.





5. REMOVE TILT AND TELESCOPIC MANUAL SWITCH

(a) Disconnect the connector.





(b) Using a screwdriver, detach the claw and pull out the tilt and telescopic manual switch.

NOTICE:
Pushing on the claw too hard will break the claw.

HINT
Tape the screwdriver tip before use.