Audio Digital Signal Processing (DSP) Module

Audio Digital Signal Processing (DSP) Module









Removal and Installation

1. NOTE: Module configuration is required when a new audio Digital Signal Processing (DSP) module is being installed.

Upload the audio DSP module configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)

2. Remove the RH quarter trim panel.

3. Disconnect the audio Digital Signal Processing (DSP) module electrical connectors.

4. Remove the 3 screws and the audio DSP module.
- To install, tighten to 7 Nm (62 lb-in).

5. To install, reverse the removal procedure.
- Download the configuration information from the scan tool. For additional information, refer to PMI in Information Bus. Programmable Module Installation (PMI)