B-Pillar Trim Panel

B-Pillar Trim Panel

Removal and Installation

Lower trim panel

1. Remove the instrument panel side finish panel.
- Pull outward to release the retaining clips.

2. Remove the lower A-pillar trim panel.
- Pull outward to release the retaining clips.

3. NOTICE: When removing scuff plate trim panels with the Lincoln ambient lighting, care must be taken not to damage the aluminum insert.

Remove the front door scuff plate.

- Using a flat trim tool, lift upward on the scuff plate to release the clips.

- Disconnect the ambient light electrical connector.





4. Remove the rear door scuff plate.
- Using a flat trim tool, lift upward on the scuff plate to release clips.





5. Remove the lower B-pillar trim panel.
- Pull outward on the trim panel to release the clips.





Upper trim panel

6. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.

Remove the safety belt D-ring cover.





7. Remove the safety belt D-ring bolt.
- To install, tighten to 40 Nm (30 lb-ft).





8. Remove the upper B-pillar trim panel bolt and remove the upper B-pillar trim panel.





All trim panels

9. NOTICE: To avoid damage to the B-pillar trim panels and the scuff plate trim panels, remove any retaining clips from the body and attach them to the trim panels before installing.

To install, reverse the removal procedure.