Seat Cushion Cover - Front

Seat Cushion Cover - Front

Removal and Installation

1. Remove the front seat. For additional information, refer to Seat - Front Seat - Front.

2. From under the rear of the seat, separate the carpet flap toe-kick.

1. Separate the J-clip from the cushion frame.

2. Peel the carpet flap toe-kick up and remove the pin-type retainers from the cushion side shield and recliner cover.





3. NOTE: The seat track rear height adjust must be all the way up to access the cushion cover retainer.

Remove the cushion cover retainer near the safety belt buckle.





4. From the front of the seat, disengage the wire harness retainer and disconnect the seat control switch electrical connectors.





5. Remove the cushion side shield.

1. Remove the scrivet at the back.

2. Remove the screw at the front.

3. Pull out at the side to release 3 clip retainers.
- At installation, return all retaining clips back to the cushion side shield before installing the shield.

4. Slide down and separate the hook.





6. Disengage the cushion cover retainers attached to the cushion frame. Pull the cushion cover out from between the cushion and backrest.

7. Invert the cushion cover, remove the hog rings and the cushion cover.

8. To install, reverse the removal procedure.