Selector Lever Bezel

Selector Lever Bezel









Removal

1. Remove the selector lever knob. For additional information, refer to Selector Lever Knob Selector Lever Knob.

2. If equipped, remove the rear floor console trim cover.

1. Pull up on the back of the trim cover.

2. Pull back on the trim cover.

3. Disconnect the electrical connector.





3. Remove the cupholder.

1. Pull up on the cupholder.

2. Disconnect the electrical connector.





4. Remove the 2 center console side trim panels.





5. Remove the selector lever bezel.

1. Remove the 2 screws.

2. Pull up on the back of the selector lever bezel to release the retainers from the center console.

3. Pull back on the front of the selector lever bezel to release the retainers from the center console.

4. Disconnect the electrical connector and remove the selector lever bezel.





6. Unlatch the 7 tabs and remove the selector lever boot retainer.





7. Remove the 6 screws and remove the selector lever boot from the selector lever bezel.





Installation

1. Position the selector lever boot on the selector lever bezel and install the 6 screws.





2. Install the selector lever boot retainer on the selector lever bezel and latch the 7 tabs.





3. Install the selector lever bezel. Connect the selector lever bezel electrical connector. Install the selector lever bezel on the center console and install the 2 screws.





4. Install the 2 center console side trim panels.





5. Install the cupholder. Connect the electrical connector and install the cupholder in the center console.





6. If equipped, install the rear floor console trim cover. Connect the electrical connector and install the trim cover on the center console.





7. Install the selector lever knob. For additional information, refer to Selector Lever Knob Selector Lever Knob.