Engine Oil Dip Stick - Dip Stick Tube: Service and Repair

-
OIL LEVEL INDICATOR AND TUBE REMOVAL/INSTALLATION - HYBRID










1. With the vehicle in NEUTRAL, position it on a hoist. See Lifting.

2. Remove the oil level indicator.

3. Remove the pin-type retainer, the 5 bolts and the RH splash shield.

- To install, tighten to 9 Nm {0.9 kgf-m, 6.6 ft-lbf}.

4. Remove the lower oil level indicator tube bolt.

- To install, tighten to 47 Nm {4.8 kgf-m, 35 ft-lbf}.

5. Remove the 2 bolts and position the motor electronics coolant pump and ground strap aside.

- To install, tighten to 20 Nm {2.0 kgf-m, 14.7 ft-lbf}.






6. Remove and discard the oil level indicator tube O-ring seal.

7. To install, reverse the removal procedure.

- Lubricate a new O-ring seal with clean engine oil.