Programming and Relearning

DSC/RSC SENSOR INITIALIZATION PROCEDURE

WARNING:
- Unless the initialization procedure of the combined sensor is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC/RSC operation if the combined sensor and DSC/RSC HU/CM have been removed or replaced.

1. Inspect the wheel alignment and inflation pressure.

- If there is any malfunction, adjust the applicable part.

2. Park the vehicle on level ground.

3. Turn the ignition switch off.

4. Connect the M-MDS to the DLC-2.






5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

1 Select "Chassis".
2 Select "ABS/DSC".
3 Select "Sensor Initialization".

- When using the PDS (Pocket PC)

1 Select "Module Test".
2 Select "ABS".
3 Select "Datalogger".
4 Select "SSR_INTL".

6. Perform the initialization according to the directions on the screen.