Power Trunk / Liftgate Hazard Tone Speaker: Service and Repair

POWER LIFTGATE (PLG) BUZZER REMOVAL/INSTALLATION

CAUTION:
- Do not remove the PLG buzzer except when replacing the PLG buzzer because thread-locking compound has been applied to the screws.

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Liftgate upper trim (See .)

b. PLG arm (See Power Liftgate (PLG) Drive Unit Removal/Installation.)

c. Liftgate side trim (See .)

d. Liftgate lower trim (See .)

3. Disconnect the PLG buzzer connector.






4. Remove the bolt.

5. Remove the clip.

6. Remove the PLG buzzer.

7. Install in the reverse order of removal.