Shift Cable: Adjustments

SELECTOR CABLE ADJUSTMENT

1. Remove the following parts:
a. Side wall.

b. Heat insulator (front and center).

c. Selector lever knob and indicator component.

d. Center console. Center Console Removal/Installation

2. Shift the selector lever to the P position.

3. Loosen the nut of the selector cable end (selector lever component side).






4. Verify that the manual shaft is in the P position.

5. Install the nut of the selector cable end in such a way that the selector lever does not bear a load.

Tightening torque
- 10-15 Nm {102-152 kgf-cm, 89-132 in-lbf}

6. Verify that the selector lever bolt end is exposed from the nut.






7. Install in the reverse order of removal.

8. Shift the selector lever from the P position to M range, and make sure that there are no other components in that area to interfere with the lever.